UTG Navy Commando Airsoft Electric Pistol

WARNING: NOT A TOY. FOR AGES 18 YEARS AND UP. MISUSE OR UNSAFE USE MAY CAUSE SEVERE INJURIES. EYE PROTECTION REQUIRED. THE PURCHASER AND THE USER SHOULD READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE USING THE GUN AND SHOULD OBEY ALL LAWS CONCERNING THE USE AND OWNERSHIP OF AIRSOFT GUN. DO NOT BRANDISH OR DISPLAY THIS PRODUCT IN PUBLIC – IT MAY CONFUSE PEOPLE AND MAY BE A CRIME. POLICE AND OTHERS MAY THINK IT IS A FIREARM. DO NOT CHANGE THE COLORATION AND MARKINGS TO MAKE IT LOOK MORE LIKE A FIREARM. THIS IS DANGEROUS AND MAY BE A CRIME.

·   Always treat the airsoft gun with the same respect and safety precaution as you would with a firearm.

·   Airsoft gun must be kept out of the reach of minors.

·   Always wear protective goggles for airsoft sport.

·   Use .12g BBs only. Strongly recommend using UTG Premium Precision Ground 6mm BB Pellets. Low quality BB pellets may clog and damage the rifle. Do not re-use BBs.

·   DO NOT MODIFY OR ALTER YOUR AIRSOFT GUN. Attempts to modify the airsoft gun in any way inconsistent with this manual may make it unsafe to use and cause serious injuries.

WARNING – CAUTION

Never look into the barrel with bare eyes.

Never point the gun to another person.

Do not shoot at any target with hard surface within close range. Ricochet pellets may injure you.

Do not brandish in public; do not alter the coloration and warnings – such an action is dangerous and may be a crime.

1. Component Chart

Warning! Before you follow the assembly instruction, make sure to remove the magazine and set the Fire/Safety Selector to the “SAFE” position.

2. Battery operation and care

·   To prolong battery lifetime and maintain the best shooting performance, do not shoot over 5 minutes continuously.

·   Never deliberately short circuit batteries. Exposing the battery wires where they may come into contact with each other or to other metallic objects can cause the battery to short circuit and create a potential fire hazard.

·   Not all chargers perform the same. Please use the charger included with your airsoft gun which is intended for your battery type. Use of incompatible charge may cause danger.

·   Be sure to dispose used or damaged battery appropriately.

·   You must charge the battery for a minimum of four hours, up to a maximum of six hours, before initial use. Make sure your battery is fully charged, but never charge over 6 hours each time. This will ensure maximum performance of your new airsoft gun.

·   When putting away the airsoft gun for storage, please remove the battery from the airsoft gun. Leaving battery inside the airsoft gun without use for long periods of time may cause damage to the airsoft gun or cause danger. Store the battery in a cool, dry place when not in use.

Never disassemble the battery.

Batteries can explode or cause burns if exposed to liquid, chemical, fire or high temperature.

Let the battery cool before charging.

3. Operating the Safety/Fire Selector

·   To set the Safety/Fire Selector at “SAFE” position, push the selector vertically all the way down (Fig 3.1).

·   To set the Safety/Fire Selector at “FIRE” position, push the selector vertically all the way up (Fig 3.2).

Warning! Always use UTG Premium Precision Ground .12g 6mm plastic BB Pellets only for accuracy and safety.

Note: Use .2g BB might cause unexpected jamming and would void warranty.

4. Loading Pellets

·   Make sure to set the Safety/Fire Selector at “SAFE” position.

·   Hold and disengage the magazine by pressing the Magazine Release Button. (Fig 4.1)

·   Push 6mm pellets into the magazine through the Pellet Drop. (Fig 4.2)

·   Insert the loaded magazine back into the pistol.

5. Installing/Replacing Battery

Installing Battery

·   Make sure to set the Safety/Fire Selector at “SAFE” position.

·   Holding the airsoft pistol and pressing the Battery Cover Release with one hand, pull the Cocking Slide Cover up and off with the other hand. (Fig 5.1)

·   Align the arrow on one end of the battery with the white plastic slot in the pistol. Slide the battery in as shown in Fig 5.2. Push the battery in all the way. (Fig 5.2 and Fig 5.3)

·   Fit and slide the Cocking Slide Cover over the end of Muzzle, and push down until it is locked in place.

Removing Battery

·   Remove the Cocking Slide Cover.

·   Locate the Battery Release Lever on the left side of the airsoft pistol, and push the release lever down to release the battery.

6. Semi Auto and Full Auto Firing (Use .12g 6mm BB Only)
(Ensure complete safety of environment before firing.)

Warning! Activating the trigger carelessly is extremely dangerous. Never set the Safety/Fire Selector on the “FIRE” position or put your finger on the trigger unless you are ready to shoot at a target.

·   Set Fire/Safety Selector to the “Fire” position. (Fig 6.1)

·   Set your airsoft pistol at Semi or Full Auto position.

·   Hold the gun firmly and aim the airsoft pistol at your target. Pull the trigger to fire.

7. Adjust the Hop-Up System for Best Shooting

·   The airsoft pistol is manufactured with adjustable Hop-Up System.

·   Locate the Hop-Up Switch as showing in the Fig 7.1.

·   Rotate the Hop-Up Adjustment Switch to a desired position.

·   Shoot a few pellets, examine the trajectory and make further adjustment if necessary.

8. Maintenance

·   Keep the airsoft pistol in clean conditions.

·   Regularly clean the barrel with a soft cleaning rod.

·   Never use dirty, damaged or distorted pellets.

9. Battery Warning

·   Examine battery quality and appearance before use each time and make sure that there is no leaking or any deformation. Dispose appropriately if there is a problem.

·   The battery is a rechargeable battery and comes with a compatible charger. Do not use any other charger incompatible with this battery type. Misuse may cause fire and danger.

·   Always remove battery from the airsoft gun after use. Leaving battery in the airsoft gun without use for long period of time may cause damage or danger.

·   Never deliberately short circuit battery. Prolonged short circuit will cause the battery to lose energy and result in significant temperature increase.

·   Keep battery compartment clean and keep any metallic object away from the battery.

·   Battery can explode or cause burns if disassembled, shorted, exposed to water, fire, or high temperatures. Do not place battery in a pocket, purse, or other container containing metal objects. Do not store battery with hazardous or combustible materials. Store in cool, dry, ventilated area. Follow applicable laws and regulations for disposal.

·   Keep battery out of reach of children.