|
HFC
HG-133 6" Barrel Gas Revolver
|
|
Instructions Manual |
|
|
|
When refilling the gas, place the
pistol at an angle of 18° (if the refilling angle is too large, it may cause leakage
of gas.) The gas refilling operation usually takes 2-3 seconds and it is
recommended that the gas pressure shall be maintained at 6-10 kg. |
|
|
Safe switch (bullet ejection button) Push the safe switch along the arrow
line and toward the utmost end, and sign off the revolving shaft. |
|
|
Load BB bullet in the front of
cartridge, then put into the cylinder. |
|
|
Place the magazine into the revolving
shaft and push forward into fire position. |
|
|
The most optimal fire rate is an
interval of 2 seconds. Too fast firing freezes the air cooled chamber. It is
strongly recommended to fire at the indoor temperature ranging from 15° C to
35°C. |
|
|
Pull the revolving shaft backward to
the far end so as to keep it in safe position. |
|
|
After a long and continued firing
practice, the low temperature of the gas chamber will cause a reduced gas
pressure as well as the low velocity of bullet. It is a normal condition, not
a problem. |
|
|
Never practice the reverse firing for
this action renders the gas hardness to violate and to produce the atomized
gas of ejection which leads the damaged to the parts. |
|
|
Adjust the hit spot as shown in the
figure (Left à right). |
|
|
It is normal for a haze to emerge
from the gas channel after fast or long period of firing. |
|
|
Cartridge loading diagram Load BB bullet in the front of
cartridge, then put into the cylinder. |
|
|
|
|
Follow trouble shooting procedure as
indicated in the instruction. |
||
|
Condition |
Causes |
Correction |
|
No action |
Safety is locked |
Release the safety |
|
Unknown reason |
Please contact our distributor. |
|
|
No load of bullet |
Deformed BB bullet |
Use the standard BB bullet only |
|
The bore is clogged with extraneous
material |
Remove the extraneous material from
the bore |
|
|
Short projectile |
The ambient temperature is too low |
If the outside temperature is too
low, use it indoors. Until the gun temperature recovers |
|
A long and continued firing causes
quick cooling and frozen |
It can be used again when the gun
temperature recovers. The operation temperature is between 15°C to 35°C |
|
|
Low gas pressure in the Gas chamber |
Refill the gas |
|
|
Caution! |
|
|
|
|
|
|
|
|
|
|
|
|
|
