Fire mode: Semi / Full Auto
Muzzle velocity: 375 fps w/ .2g
Effective range: 180 feet
Hop Up: Adjustable
Weight: 6.25 lbs
Magazine capacity: 500rd
Length: 19.75 - 28.75
Battery: 8.4v AK Stick Type
|
Operation: Electric Fire mode: Semi / Full Auto Muzzle velocity: 375 fps w/ .2g Effective range: 180 feet Hop Up: Adjustable Weight: 6.25 lbs Magazine capacity: 500rd Length: 19.75 - 28.75 Battery: 8.4v AK Stick Type |
|
|
|
|
Use the specified battery for the gun. 8.4V, 1100mAh Hyper Command Mini Battery. Avoid use of non-standard or other brand name batteries. Otherwise, the originially designed functions will not be obtained. Warning: The SD and Mini Battery can not be used. Use the specified battery charger which is applicable to the above battery. The charger Excusive Type as Speed Charger. The battery's capacity power is increased with use of the Exclusive(battery) Discharger (Sold separately) Use the correct battery and charge according to respective instruction manuals. We will not be held responsible for any accidents or damage caused by wrongful operation or usage of non-specified batteries. |
| back to top | |
|
|
| To prevent malfunction of the switch do not change the selector
lever from semi to full auto while pulling the trigger.
Warning: Set the selector lever correctly in position otherwise, malfunction may occur. |
Safety setting (the trigger cannot be pulled.) When you are not firing the gun or during storage always set the selector to the safe position. |
|
|
|
Fully automatic (automatic firing)
The gun will fire automatically while the trigger remains pulled. |
Semi automatic
The gun will fire one shot each time the trigger is pulled. |
| back to top | |
|
|
| Press the upper cover catch button and upper cover pop-up automatically. | Connect the battery to the cord that is accessible from the hole under
the rear sight. Press in the battery with its protrusion facing to the
left. The protussion must be on the left side. |
|
Reinstall the receiver top in the reverse order of removal procedure
in step (1). Align the lead edge of receiver top to the groove under the
rear of receiver top, aligning to the groove shown. When receiver top is set correctly, the catch button ejects out. |
| back to top | |
 |
|
| Open the cover of the magazine | Insert 6mm BB bullets into the loader (500 bullets can be loaded) |
 |
|
| Replace the magazine cover |
Set the magazine upward. install the magazine as illustration. 1. First set the front. 2. Press to the rear. 3. Press the release lever towards the trigger to lock. |
 |
|
|
Move the gear with hand clockwise until it is fully wound, and the bullets
will be sent up automatically. (It can send about 150 rounds automatically.) The magazine is capable of Containing 500 BB bullets. |
Slide the rib in the arrow dirrection to remove remaining BB bullets. (Be careful since BB bullets may jump out.) |
 |
Always use the BB bullets for the air gun. We shall not be held responsible for any damage or accidents arising from the use of bullets supplied by other manufacturers. |
| back to top | |
|
Caution: Be careful so that your skin and fingers do not get caught in the folding parts. Press the gun stock release button 1, move forward the gun stock. |
|
|
| Variable hop-up adjustment lever |
Installation of the eliminate blaze implemen 1. While pressing the lock button. 2. The eliminate blaze implement is fixed by counterclockwise as in the case of real gun. |
|
|
|
Insert the front sight adjustment tool in the front sight and turn it
for adjustment. Counterclockwise:lower sight point Clockwise: higher sight point Be careful so as not to lose the adjustment tool. |
Rear Sight: Turn to front:short distance Turn to rear: Long distance |
|
|
|
Setting the hand guard Need to open the upper cover to take out the upper hand guard set. Put the upper hand guard set first to close the upper receiver |
Pull the lower hand guard locking lever back, and push the fasten base ahead. Pull back the lower hand guard back and won to take off the lower hand guard. |
| back to top | |
|
|
Caution: A blank firing may occur at triggering after
the magazin, this is the normal operation of the gun. 1. Set the selector lever to Semi or Full auto. 2. Pull the trigger. Caution on Motor and Battery After Operation Charge the battery if the firing cycle becomes slow. Give the air gun a rest for 5 to 10 minutes after firing about 500 rounds, in order to ensure long service lives of the motor and battery. When Bullets are Clogged If bullets are clogged, remove them and apply a few drops of silicone oil in to the chamber from the magazine entrances shown or spray silicone oil for 0.5 or 1 sec, to obtain smooth continuous. |
| back to top |
|
After Operation Always attach the protective cap during storage |
|
Caution There are possible cases that no firing occurs after pulling the trigger in the semi-auto mode. In this case, do not pull the trigger furiously. Fire 5 to 6 shots in the full auto mode and then return to the semi auto operation. Smell may be generated from motor for a while when a new air gun is operated. This is the normal operation of the gun. The hopping up operation may be unstable for 200 to 300 rounds after using silicone oil, this is the normal operation of the gun. |
|
| back to top | |
| Symptom | Cause | Action |
| No operation at all | Selector level is set to safety | Set the selector lever to Semi or Full Auto |
| Battery is not charged. | Charge the battery. | |
| Battery connector is disconnected. | Connect the connector. | |
| The + and - or battery connector is reverse. | Connect the connector correctly (check the fuse) | |
| Fuse is blown out. | Replace the fuse. | |
| Expired motor life (50,000 to 60,000 rounds) or poor electrical connection. | Replace the motor (purchasing from your dealer or check and repair the contacts) | |
| Although motor is moving, no bullet jump out. | BBs are clogged in the magazine. | Insert the charging rod into the magazine and move up and down a few times to remove clogged bullets. |
| BBs are clogged in the chamber. | Remove clogged bullets using the cleaning rod. | |
| Faulty gear | Purchase the replacement gear from your dealer and repair. | |
| Impossible full-auto operation (automatic firing) | Insufficient battery power | Charge the battery |
| Faulty BBs feed of magazine | Repair clogging of the magazine. | |
| Impossible semi-auto operation (single shot) | Poor electrical connection | Consult your dealer for overhaul maintenance or repair. |
| Deviation in gear timing | Set to semi auto after firing 5 to 6 rounds in full auto. |
| Never use BBs other than those supplied by us. Use of poor quality BB bullets will cause problems. Never diassemble or modify the gun. | ||
| Symptom | Cause | Action |
| Impossible semi-auto operation (single shot) | Insufficient battery power | Charge the battery |
| Automatic firing cycles become long. | Insufficient battery power | Charge the battery |
| Shooting distance become shorter | Worn or damaged chamber packing (O-ring) | Consult your dealer for overhaul maintenance or repair. Replace the chamer packing, piston assembly. |
| Worn or damaged chamber packing. | ||
| Deteriorated piston spring | ||
| Faulty BBs (too small or too heavy) | Use genuine BBs. | |
| Shortage of damaged gear | Drop a few drops of silicone oil from under the chamber. | |
| Gear problem caused by too many blank firing | Consult your dealer for overhaul maintenance, part replacement (gear, etc.) or repair. | |
| Too loud operating noise | Gear problem caused by too many blank firing | |
| Bullets being fallen out from barrel end | Worn or damaged chamber packing | |
| NO hop setting | Turn the hop adjustment dial toward HOP | |
| Faulty BBs (too small) | Use genuine BBs. | |
| Being wet by or dropped into water (rain) | Stop operation immediately, disconnect the battery, wipe off water from inside the main body and the battery, and, after complete dry, carry out trial firing. If no operation or malfunction is detected, consult your dealer or us for repair. | |
| back to top | ||
| By producing a back-spin to the BB bullets, this system allows for straighter and longer distance shooting than normal air gun. Unlike the fixed type, the variable hop up system permits one-touch adjustments using the dial and lever, making it an ideal hop up system. | |
|
Adjustment Procedure (Adjust by carry out trial firing)
Graduall turn the adjustment dial towards Hop to give hop up to bullets. (The best setting is where bullets fly horizontally.) Turning excessively adversely affects the trajectory. So stop turning the hop adjustment lever when bullets fly horizontally. |
|
The best position is where the bullets fly horizontally, and the longest
flying distance is obtained. Too much hop-up (return the lever towards NORMAL) Straight best position |
|
Operational Caution: Strictly observe the following
caution) |
|
If bullet clogging occurs, immediately stop firing the gun, return the
hop lever to the Normal positioning and remove clogged bullets using cleaning
rod. Make sure to return the hop adjustment lever to the Normal position when removing clogged bullets or cleaning. (Otherwise, the chamber packing is damaged.) Never use used or dirty bullets. (Otherwise, the chamber becomes dirty, resulting in unstable hopping up.) When about 10,000 rounds are fired, spray silicone oil into the chamber for 0.5 to 1 sec. (See 11 on page 8. The hopping up operation may be unstable for 200 to 300 rounds after spraying the silicone oil, this is the normal operation of the gun.) We will not be held responsible for any damage or accidents arising from wrongful operation, disassembly and modification of the gun. Any costs for repair of such damage shall be paid by the user. | |
|
Caution: If the hop-up is adjusted excessively causing clogging of bullets, immediately stop operating the gun. Return the lever to Normal, fire to 2 or 3 shots and readjust. Since a precision tight barrel is used, use of dirty bullets or those with burrs causes clogging of bullets and possible fatal damage to the mechanical box and system. Warning: Never hold the gun side ways the Bb bullets will curve right or left. This is due to the HOP-UP adjustment. |
|
| back to top | |
| When Hopping Up is Improper | ||
| Symptom | Cause | Action |
| Bullets flying upwards. | Too much setting | Gradually return adjustment lever towards normal |
| Short flying distance of bullets (less hopping up effect) | Too much hop setting | Gradually return adjustment lever towards Normal. |
| Hop packing contaminated by oil or dirt. | Fire bullets equivalent to 4 or 5 magazine or clean the chamber using cleaning rod | |
| Worn or damage hop packing | Purchase the replacement part at your dealer | |
| Cannot adjust | Damaged adjustment lever or other parts | Purchase the replacement part at your dealer and replace it. |
| Frequent bullets clogging | Too much hop setting | Gradually return adjustment lever towards normal. |
| Improper or too large sized BB bullets | Use the BB bullets for Electric Gun. | |
| Dirty hop packing | Clean using the cleaning rod or consult your dealer for repair. | |
| back to top | ||
 |
1. Fuse replacement procedure |
|
2. Removing Clogged Bullets (Set the Safety button to ON and remove the magazine beforehand.) |
|
|
Insert the Cleaning road into the bore. |
|
Be careful so that the angled part of the Cleaning Rod faces down, and remove clogged bullets Caution: The ornamental can not be used for cleaning the obstruct bullets. Make sure to insert the cleaning road AFTER returning the hop up lever to the Normal position. (Hop-OFF) |
| 3.Maintenance when bull speed becomes low | |
 |
|
| Cut the cotton to the size shown. Adjust the length accordingly so that it can be inserted smoothly into the barrel. | |
| |
| Hold at the leading end of the rod and insert the rod into the barrel while turning the rod. | Caution: Inserting the rod will be difficult if you hold rod at the end. |
| |
|
1.Apply a few drops of silicone from the bullet entrance, insert BB bullets into the magazine and fire bullets and ire bullets equivalent to 1 or 2 magazine. 2. To complete the cleaning, Use the cleaning rod (with cotton) as shown,
to remove excess oil. Always carry out maintenace AFTER returning the hop up lever to the Normal position. (Hop-OFF) |
|
| back to top | |
 |
Remove the screw from the grip bottom. M3 hexagon wrench Insert M3 hexagon wrench into the screw hole adjust |
| Hold the grip during adjustment. Otherwise, the main
body will drop since the grip set screw is removed. It is recommended to lock the adjustment screw by a screw locking agent or instantaneous adhesive after adjustment of the motor position is complete. Normally, do not attempt to adjust. Be careful not to overly tighten screw as it will damage the gun. |
|
| back to top | |
|
||||||||||||||||||||||||||||||||||||||||||
|
||||||||||||||||||||||||||||||||||||||||||
| back to top |
|
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| back to top |
|
|
This product is an airsoft airgun, it is to be purchased by person(s) age eighteen (18) years or older.
Adult / parental supervision is required when used by any person under age of eighteen. Be responsible, check with your local law enforcement on airsoft airgun regulations. Please read the operation manual and fully understand the safe handling of your airsoft airgun before use. Pay special attention to your surrounding when using your airsoft airgun. Do not carry your airsoft airgun in public, in open view or concealled. Transport your airsoft airgun unloaded, in locked gun carrier / case. Do not brandish, point, or shoot at other people, animal, or private properties. Such actions may be preceived by others (including law enforcement officer) as a threat and prompt to react accordingly. U.S. federal regulation requires the orange marking, do not remove, alter or impair marking. All warranty void if markings(s) are tempered. This airsoft airgun is for safety & handling training purpose, movie and theatrical production application, regulated airsoft sport at participating playing field and shooting range. Ask your airsoft dealer for details. Store your airsoft airgun unloaded, remove batteries, discharged of any gas or spring tension. In a safe and locked location; out of the reach of children. |
| back to top |